Garage Doors. Thursday , October 12th , 2017 - 01:50:41 AM
This weakening of the springs or points of attachment would often lead to an inadvertent explosive failure flinging the broken spring components across the garage, embedding the spring or steel components into the garage walls, cars or other items in the path of travel. Unfortunately, sometimes people were in the path of travel of these explosive occurrences. As these springs failed, as an attempted safeguard, some manufacturers devised a "caging" system for the springs. These cages were retrofitted onto the stretched springs in an attempt to capture the parts that would release if a failure occurred. While these caging devices were helpful, they were not completely effective. Some of these spring devices are still in use today. Whenever this condition exists or the quality of garage components are questionable, a qualified professional service technician should be consulted.
In the past, the biggest concern with operating an overhead garage door was the potential risks associated with the springs used for balancing the door weight. Pre mid 1960s garage door installations typically relied upon a pair of stretched (tensioned) springs to assist the operation of the garage door pivoting hinges. These springs became loaded (tensioned) as the door was moved into the closed position. Unloading (releasing) of the stored spring energy occurred as the door was opened to the horizontal overhead position. One of the most dangerous aspects of these spring systems was that after a period of time, often without any maintenance or inspection, the points of attachment of these springs would rust or become weak.
In response to the inherently dangerous old style garage spring issues as above, a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end, while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables, connectors and pulleys, the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring, the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does ShirtsTasteGood claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.