Door Hinges. Sunday , September 03rd , 2017 - 07:41:42 AM
Geared continuous hinges are most often found in steel or aluminum. Lighter weight continuous piano hinges are often made of brass. The heavy duty commercial hinges distribute weight and stress along the full length of door and frame, thus preventing misaligned pivot points of individual hinges. Buyers should look for high quality hinges from well-known manufacturers. Cheaper products provide inferior performance and will require repair and replacement long before a higher grade hinge. Companies such as Stanley even provide a limited lifetime warranty on their commercial grade door hinges.
Another way to tell if it is a good idea to replace your doors with pre-hung replacements is if the rest of the doors already cant in their frames. You can square them yourself, but if you are planning to replace these doors, go for the pre-hung. They take much less time to replace and come in pre-finished or raw wood. One last thing, is your door a left- or right-hanging door? Hmmm...you think for a minute. Nope, you are sure you havent heard that one. Dont worry its easy. When you are buying any type of hinged door; storm door, entry door, and even cabinet doors, OR when you are buying hinged door hardware; hinges especially and sometimes latches, the salesperson will eventually ask you whether it is a right- or left-hanging door. The way you figure it out is, when you pull open the door; does it open to your left or to your right? Whichever way it opens is the answer.
Another related lefty-righty question is: Does it really matter if you mix up right- and left-hanging cabinet door hinges? Not usually. Most door and cabinet door hinges can masquerade as each other if you rotate them 180°. The pins will drop in the same way and everything. In rare cases, the pin only goes in one way, the cabinet door hinges plate is shaped or decorated to only look right on its right (or left!) side. If in doubt, ask a contractor or cabinetmaker. Tip: If you are going to take your old doors or cabinet doors off, refinish them, and put them back on, I suggest labeling each of the cabinet door hinges as you take them off. In your kitchen for example, the top left-hanging hinge on the first cabinet on the east side of your kitchen could be marked: TLE1. That way everything will line up exactly as it did before you took them down.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does ShirtsTasteGood claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.